Skip to main content

Posts

Showing posts from November, 2012

Solving error code C0840001 on HP printers

The error code C0840001 appears on HP printers like D1660, F2180... Sometimes, you can ear a grinding noise. Solution 1 : Turn printer off.   Open the door. With a flashlite, look inside to the right side where is a small tray that slides forward and backwards.   Push the tray forward until it stops then move it backwards until the little black tab on the right is 1/2 inch from the metal part of the carriage.   Close the door.   Turn printer on.   Solution 2 : Look for a spring and lever arm with some small gears. It is located to the left of the printer, near the guide rail.  Put a couple of drops of oil on the gears and lever pivot shaft.

Solving error message "clean sensor" on Epson Aculaser C2600

Le message " Clean Sensor " ou "Détecteur Nettoyage" a plusieurs causes. Solution 1 : The firts thing to do: open the cover (cover D): Close it very slowly: it will clean the sensor. Do it 2 or 3 times in succession: Solution 2 : Open the front cover (cover D) Remove the waste ink box. Clean the photoconductor wire: hold the cleaning knob and move it slowly in and out a few times (5-10 times): Clean the exposure window: hold the knob (under the photoconductor cleaning knob) and move it slowly in and out a few times (5-10 times).  Put back the waste ink box. Close the cover Power off the printer during 5 minutes Solution 3 : When using remanufactured toner. Verify each toner. Solution 4 : Look inside the transfert belt if a roller did not go out of its axis.

How to solve USB001 Operator error on printers

Solutions for " USB001 Operator error ": Solution 1: Disconnect the USB cable and the power cable from the printer.  Power off the printer and the central unit. Wait a minute. Connect the power cable to the printer. Power on the printer and open the cover.  Power on the central unit and connecte the USB cable to the printer. Closer the cover. Solution 2 : Uninstall the driver of the printer Reinstall the driver. Solution 3 : Try another USB port. Solution 4 : The electronical car of the printer may be faulty.

How to reset waste ink pad on Canon Pixma MP280

Error P07 means the waste ink counter is full. Solution 1 : First, search and download the Service Tool V1074 . Turn off the printer Hold down the "stop/reset" and press the "power" button without release it. Release the "stop/reset". Press the "stop/reset" button six times and release the two buttons. The printer is now in service mode. Extract the Service tool and the file to open service tool page Find the "clear ink counter" section and click on the "main" button. Scroll down to find "ink absorber counter" on the left and to the right of that "counter value". Ink absorber counter box should read "main" and counter value reads "0". Click the set button to the right of the counter value box. The printer will now make some noise and will print a page of paper,. A message will tell you when the process has been completed. Click on the prompts. Turn the printe

Solving error code 2,140,21 or 2140,21 on Canon printers

MAJ 11/06/17 Error 2,140,21 or 2,157,50 appears on Canon printers when the scanner is used. " Printer is in use or an error has occurred. Check status. Scanner driver will be closed. Code : 2,140,21 " Solution 1 : On Windows: go to "devices" Click on "Printer" Click on "Stop printing". Solution 2 : Reinstate the driver of the printer. Solution 3 : Turn off the firewall Solution 4 : Sometimes, replacing the cartridge could solve the problem.